Free US shipping over $35·100+ prints per sheet·Made in USA since 2014
Home / Resources
Resources

Everything you need to nail every print.

Guides, settings, compatibility, and answers — so your first layer sticks and your parts pop off clean, every time.

Setup guides

How to apply EZ-Stik

Measure, cut, and bubble-free application in under two minutes.

Read guide →

Temperature settings

Dialed-in bed & nozzle temps for PLA, ABS, PETG, Nylon & flexibles.

View chart →

Care & longevity

Keep a single sheet running past 100 prints — cleaning & do's/don'ts.

Read guide →

Printer compatibility

Find the exact sheet & size for your printer

Browse 50+ popular printers, or enter your bed size for any printer ever made.

Browse printers →

FAQ

Will it fit my printer?
Yes — EZ-Stik ships oversized and cuts to any bed with household scissors. Use the printer finder for the closest fit, or enter your bed size.
Does it work over a textured PEI plate?
EZ-Stik HOT lays over your existing plate and gives a smooth, consistent surface with strong adhesion for ABS/PETG/nylon — and a glassy bottom finish most stock plates can't match.
How many prints does one sheet last?
100+ prints is typical; many users report 200–300 with good care. When adhesion finally fades, peel and apply a fresh sheet in minutes.
HOT vs COLD — which do I need?
HOT for heated beds and engineering materials (ABS, PETG, nylon). COLD for unheated beds, PLA, flexibles, and classrooms. When in doubt, the Sample 3-Pack has both.
Do you ship internationally?
We ship worldwide from the USA. US orders over $35 ship free.

Troubleshooting

First layer won't stick
Clean the surface with IPA, re-level so the nozzle is a hair closer, and match the bed temp on our settings chart. A slightly slower first-layer speed helps too.
Parts stick too hard when cool
Let the bed cool fully — EZ-Stik releases as it drops below release temperature. A gentle flex of a flexible plate or a few extra minutes cooling pops it free.
Bubbles under the sheet
Peel back to the bubble, smooth outward from the center with a card, and re-lay. Small bubbles away from the print area won't affect results.
Sheet lifting at the edges
Ensure the bed was clean and dry before applying. Trim any overhang past the heated zone; overhanging film can catch and lift.